Retractable faucet. The telescopic faucet of the present invention is composed of a faucet body and a rocker arm. The rocker arm is connected to the faucet body by a sleeve screw. One end of the sleeve screw is screwed to the rocker arm, and the other end is a fixed ring with a fixed ring. . The sealing ring and the stopper inserted into the main body of the faucet and fixed by the decorative nut, and the outlet at the top of the outlet arm, the outlet is connected to the other end of the rocker arm by a sleeve screw. This design allows the mixer to be stretched horizontally and vertically by rotating the plug, so that it can be adapted to specific requirements.
The countertop can be cleaned at will. If you want to wash your hair conveniently, if it is broken, it is not easy to repair, high quality and low price, convenient to wash your hair, inconsistent before and after, the top basin is good, but it is more expensive. The basin is rarely used, easy to repair, and the basin is too large. It is recommended to use a highly curved 360° rotating faucet. Retractable faucets are usually used in washbasins.
Installation method of Telescopic Faucet
Installation of single hole basin faucet
When purchasing a single-handle basin faucet, pay attention to the diameter of the spout. Most faucets on the market are hard water, so please pay attention to the height of the water inlet. The most suitable working point in the basin is 35. When installing the faucet, be sure to choose a special angle valve, which must be fixed to the hot and cold water pipes of the wall outlet. When you find a certain distance between the angle valve and the water pipe on the faucet, please purchase a special extension pipe for connection. Remember, do not connect it to any other water pipe, because if the water pressure is too high, the water pressure can easily fall and leak, causing damage. If the inlet pipe is too long and above the outlet pipe, it can be cut off as needed. If the angle is not correct, you can bend it to the desired position. Do not bend it to 90 degrees or more. When installing the basin water, please don't forget to purchase the small connector (short connection) of the faucet. Before installation, please do not forget to flush out any pipes buried in the wall.
Installation of shower and bathtub faucets (wall-mounted)
After purchasing a shower, bathtub or wall-mounted faucet, you can choose the right height to bury the pipe. The distance between the hot and cold water pipes must be 15 cm. You must not forget to flush the water pipe before installation, so as not to damage the faucet due to high water quality.
Concealed shower and bathtub faucets: After purchasing a concealed faucet, it is usually necessary to bury the faucet on the wall in advance. Be sure to pay attention to the thickness of the bathroom wall. If the wall is too thin, the spool will not be buried. Do not easily remove the plastic protective cover of the valve core when burying, to prevent cement and other debris from damaging the valve core when burying. In addition, when burying the spool, pay attention to the up and down direction of the spool to avoid the wrong spool being buried. When the wall-mounted faucet is buried in the water pipe, there will be a size deviation, which can be used to adjust the position.
Single hole kitchen faucet
The installation requires stability, because the kitchen faucet is often used, and can be moved, it is easy to loosen, so the lock nut must be tightened. Some faucets add screws in order to tighten the nuts. This stability is very good. If you can solve problems other than water, then it will be a popular trend in the future.
Before installing the thermostatic faucet, check whether the water pipe is hot to the left and cold to the right. Remember not to install the hot and cold water pipes by mistake, so as to prevent the faucet from not working properly. Due to the low water pressure, thermocouples cannot be used with gas. Please install the thermostatic faucet and don't forget to install the hot and cold water filter.