The post-processing process of film faced plywood
For the processing of film faced plywood, of course, a series of processes are required. In the later processing, which processes are required?To get more news about film faced plywood, you can visit boosterplywood.com official website.
It mainly includes preparations for leavening, removing slag, and washing. The main purpose of washing is to wash away the remaining potion on the packaging board to prevent the potion from polluting the board. Before the film faced plywood is painted, the surface of the board should be cleaned. The paint should be evenly painted. After brushing, ensure that the paint is dry. After it is completely dry, you need to sand the veneer with sandpaper until the surface is flat. Brush the paint twice, and after drying it again, check the omissions and make sure that the small holes of the board must be smoothed and clean.
Generally, three or more paint applications are required. After the construction is completed, it is necessary to continue to paint the primer twice, and to fill the pinholes left during the construction, and also use strong glue to replace the nailing method. The final recovery operation is also very important, mainly to remove some bad substances on the film faced plywood, so that in the future use, it can avoid the impact of the use of glue or potion.
ZMADTO Plywood Co.Ltd is focus on construction plywood wood formwork product. Our factory was established in 1993 and covers an area of 240,000 square meters with an average daily output of more 30,000 pcs plywood. Besides, the factory has more than 200 advanced equipment. After years of continuous development, it has become a leading company in the international wood formwork industry and exported to more than 20 countries around the world.